Kia Sorento: Rear Washer Motor Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor Inspection
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...
See also:
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Front Disc Brake Inspection
Front brake disc thickness check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Seat Heater Installation
1.
Install the driver / assist seat heater.
(Refer to Body - "Front seat")
2.
Install the rear seat LH heater and RH heater.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026