Kia Sorento: Rear Upper Arm Removal - Rear Suspension System - Suspension System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Rear Upper Arm Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Suspension System / Rear Suspension System / Rear Upper Arm Removal

1.
Remove the rear wheel and tire (A) from rear hub .

Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Support the rear lower arm (A) with a jack as shown in the illustration.
  
Certainly install Jack as being danger because of the tension.

3.
Loosen the bolt & nut and then remove the rear upper arm (A).

Tightening torque :
2WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
4WD
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

[2WD]

[4WD]

4.
Installation is the reverse of removal.
Rear Shock Absorber Installation
1. Installation is the reverse of removal.    After checking the distance 45 ...

Rear Upper Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear upper arm or damage and deformation. 3. ...

See also:

Blind Spot Detection Unit Installation
1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery te ...

Fuel Pump Motor Removal
1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). ...

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

Copyright © www.ksmanual.com 2014-2024