Kia Optima Manuals

Kia Sorento: Removal - Engine Coolant Temperature Sensor (ECTS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the engine coolant temperature sensor connector (A).
3.
Remove the spring clip (A), and then pull the sensor from the water temperature control assembly.

  
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
Inspection
1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the ther ...

Installation
   • Note that internal damage may occur when the component is dropped. If the component ...

See also:

Windshield Wiper-Washer Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after loosening 3 screws. ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P (Park) po ...

Rear Driveshaft Removal and Installation
1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Categories

Copyright www.ksmanual.com 2014-2025