Kia Sorento: Rear Hub - Carrier Disassembly
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Driveshaft and axle / Rear Axle Assembly / Rear Hub - Carrier Disassembly
| 1. |
Remove the hub assembly mounting bolts (A-4ea) from the rear axle
carrier (B).
|
| 2. |
Remove the hub assembly (C) and the parking brake assembly (B)
from the rear axle carrier (A).
|
| 3. |
Assembly is the reverse order of disassembly.
|
Rear Hub - Carrier Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the rear axle carrier for cracks.
...
See also:
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST/ :
For a single wiping cycle, move the lever to this (MIST/ ) position andrelease
it. The wipers will operate continuously if the l ...
Brake Pedal Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026