Kia Sorento: Rear Body - Body Dimensions - Body (Interior and Exterior) - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Rear Body

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body (Interior and Exterior) / Body Dimensions / Rear Body

* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]

Side outer panel rear corner

Tail gate hinge mounting hole (Ø12)

Tail gate lifter mounting hole (Ø11)

Rear combination lamp mounting hole
(Ø8)
Rear bumper mounting hole (Ø9)

Rear bumper mounting hole (20X18)



Rear bumper mounting hole (20X18)




Interior D
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front pillar ...

Under Body (2WD)
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

See also:

Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle's driver and/or the front passenger with additional protection than that o ...

Blind Spot Detection Switch Inspection
1. Disconnect the BSD switch connector. 2. Operate the BSD switch, then check for continuity between terminals of BSD switch connec ...

In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

Copyright В© www.ksmanual.com 2014-2023