Kia Sorento: Interior D
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front pillar trim mounting hole (Ø8.5) |
Front pillar trim mounting hole (Ø8.5) |
Cowl crossbar mounting hole (Ø9) |
|
|
|
|
| Front door checker mounting hole (Ø11) |
Cowl side trim mounting hole (Ø8.5) |
1st Seat belt height adjust upper mounting hole (Ø15) |
|
|
|
|
| 1st Seat belt height adjust lower mounting hole (Ø15) |
Rear door checker mounting hole (Ø11) |
1st seat belt pretensioner mounting hole (Ø12.2) |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
2nd seat belt upper mounting hole (Ø15) |
Rear door striker mounting hole (Ø13) |
|
|
|
|
| 2nd seat belt pretensioner mounting hole (Ø15) |
2nd seat belt lower anchor mounting hole (Ø15) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Quarter inner panel tooling hole (Ø15) |
Quarter inner panel trim mounting hole (Ø6.6) |
Luggage side trim mounting hole (Ø8.5) |
|
|
|
|
| Parking brake lever mounting hole (Ø9) |
Side sill inner reinforcement tooling hole (Ø7) |
1st seat mounting hole (Ø13.3) |
|
|
|
|
| 2nd seat mounting hole (Ø11) |
Floor wiring harness mounting hole (12X7) |
Rear floor panel tooling hole (Ø16) |
|
|
|
|
| Rear floor panel tooling hole (Ø15) |
Tail gate striker mounting hole (Ø13) |
Interior C
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Rear Body
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Power Tailgate Unit Circuit Diagram
...
4WD ECU Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing
with the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
...
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Copyright В© www.ksmanual.com 2014-2025