Kia Sorento: Parking Brake Pedal Assembly Adjustment - Parking Brake System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Parking Brake Pedal Assembly Adjustment

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Adjustment

Parking Brake Pedal Stroke Adjustment
1.
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.
2.
Adjust the adjusting nut(A) for parking barke pedal stoke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lbf)

  
1.
The parking brake adjustment must be carried out after adjusting the rear shoe.
2.
After adjusting parking brake, notice following matter.
1)
Must be free from clearance between adjusting nut and pin.
2)
Check securely that the brake is not dragging.
Parking Brake Pedal Assembly Installation
1. Install the holding clip (A, B) after fixing the parking brake cable. 2. Install the parking brake pedal, and then install the p ...

Parking Brake Cable Removal
Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lo ...

See also:

Start/Stop Button Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...

Auto Defogging Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defoggin ...

Smart key precautions
The smart key will not work if any of the following occur: The smart key is close to a radio transmitter such as a radio station or an airport which can interfere with normal operation of the s ...

Copyright www.ksmanual.com 2014-2026