Kia Sorento: Parking Brake Cable Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Parking Brake System / Parking Brake Cable Removal
| Parking brake pedal Type |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
| 3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
| 4. |
Remove the parking brake cable adjusting nut (A) and the fixing
clip (B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 7. |
Raise the vehicle, and make sure it is securely supported.
|
| 8. |
Remove the rear wheel & tire.
|
| 9. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 10. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 11. |
Installation is reverse of removal.
|
Parking brak e lever Type
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 4. |
Raise the vehicle, and make sure it is securely supported.
|
| 5. |
Remove the rear wheel & tire.
|
| 6. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 7. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 8. |
Installation is reverse of removal.
|
Parking Brake Pedal Assembly Adjustment
Parking Brake Pedal Stroke Adjustment
1.
Operate the parking brake pedal through a full stroke over 3 times
for setting the parking cables.
2.
...
See also:
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition (°C)°F
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.45~1.9) 0.0571~0.0748
Output voltage (V ...
Windshield Wiper-Washer Switch Installation
1.
Install the windshield wiper switch.
2.
Connect the wiper switch connector.
3.
Install the steering column u ...
4WD ECU Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing
with the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026