Kia Sorento: Output Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Output Speed Sensor Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Removal

1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Output Speed Sensor Installation
1. Install in the reverse order of removal.    • ...

See also:

Auto Head lamp leveling Unit Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No. Procedure 1 Locate vehicle to flat ...

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used ...

Pressure Sensor Circuit Diagram
...

Copyright В© www.ksmanual.com 2014-2023