Kia Sorento: Installation - ETC (Electronic Throttle Control) System - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System / Installation

  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose. (Re ...

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

See also:

AC Inverter Switch Installation
1. Install the AC switch. 2. Install the console upper cover and console upper tray. 3. Connect the negative (- ...

Replacement
Problems And Replacement Parts: Problem Part set Scan tool required? All keys have been lost Blank key (4) YES Antenna coil unit does n ...

Circuit Diagram
...

Copyright www.ksmanual.com 2014-2026