Kia Sorento: Parking Brake Assembly Removal - Parking Brake System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Parking Brake Assembly Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Parking Brake System / Parking Brake Assembly Removal

Parking Brake Shoe
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear tire and wheel.
3.
Remove the rear brake caliper and Rear disc brake.
(Refer to "Rear disc brake removal")
4.
Remove the parking brake cable (B), after removing the fixing clip (A).

5.
Remove the hub assembly.
(Refer to Driveshaft and axle - "Rear hub - carrier")
6.
Remove the adjuster assembly (B) and the lower return spring (A).

7.
Remove the upper return spring (C) operating lever assembly (D).

8.
Remove the shoe hold down pin (A) and the spring (B) by pressing and rotating the spring.

9.
Remove the brake shoes (C).
Components and Components Location
Components (1) 1. Parking brake pedal 2. Equalizer assembly 3. Parking brake cable Components (2) 1. Parking brake pedal assembly 2. Front parking brak ...

Parking Brake Assembly Installation
Parking Brake Shoe 1. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring. 2. Install the ope ...

See also:

Timing Chain Cover Installation
1. Install the timing chain cover. (1) Using a gasket scraper, remove all the old packing material from the gasket surfaces. ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Fluid Service Adjustment Procedure
Oil level Check    A check of ATF level is not normally required during scheduled services. If an oil leak is ...

Copyright www.ksmanual.com 2014-2026