Kia Optima Manuals

Kia Sorento: Oil hydraulic Motor(Actuator) Removal - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Oil hydraulic Motor(Actuator) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Oil hydraulic Motor(Actuator) Removal

1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling")
2.
Keep going perpendicular state after remove the coupling assembly.
  
While removing the hydraulic motor from the coulping assembly, make sure that the hydraulic motor keeps being vertical to the level of work table or ground as shown in the image below not to allow the coupling oil to spill out. If the coupling oil spilled out of the hydraulic motor or the coupling assembly, replace the coupling assembly with new one. (We do not recommend to add or change the coupling oil because the coupling oil's spec and fill ratio greatly effect the performance and durability of the coupling assembly.)

3.
Remove the hydraulic motor (A) after loosening bolts with hex wrench.
  
•
Remove the hydraulic motor (actuators) after dropping residual oil as much as possible inside the coupling. (about 5~10 sec)

Oil hydraulic Motor(Actuator) Inspection
   If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according t ...

Oil hydraulic Motor(Actuator) Installation
1. Before installation, wipe the surface with a clean cloth. 2. Check the O-rings (A) of the new hydraulic motor (actuators). ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

Using the USB device
To use an external USB device, make sure the device is not connected when starting up the vehicle. Connect the device after starting up. If you start the engine when the USB device is connected ...

Condenser Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdrive ...

Categories

Copyright www.ksmanual.com 2014-2026