Kia Sorento: Special Tools - Body (Interior and Exterior) - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Special Tools

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body (Interior and Exterior) / Special Tools

Tool (Number and name)
Illustration
Use
09793-21000
Door hinge adjusting wrench

Adjustment, removal and installationof the door hinge
09800-21000
Ornament remover

Trim removal
09853-31000
Headliner clip remover

Headliner clip removal
09861-31100
Sealant cut-out tool

Cutting windshield sealant
(Use with 09861-31200)
09861-31200
Sealant cutting blade

Cutting windshield sealant
(Use with 09861-31100)
09861-31000
Windshield moulding remover

Windshield moulding removal
09880-4F000
Hog ring clip installer

Hog ring clip Installation
09816-2P110
Air power tool

Air tool for installing blade
09816-2P121
Cutter-1

Blade for removing the front and side area of panorama sunroof
(This blade has a inclination to push upward.)
09816-2P122
Cutter-2

Blade for removing the front and side area of panorama sunroof
(This blade has a inclination to push upward.)
09816-2P123
Cutter-3

Blade for removing the front and side area of panorama sunroof
(This blade has a inclination to push downward.)
09816-2P124
Cutter-4

Blade for removing the front and side area of panorama sunroof
(This blade has a inclination to push downward.)
09816-2P127
Cutter-5

Blade for removing the rear area of panorama sunroof

Tightening Torque
Items N.m Kgf.m lb-ft Front and rear doors Door hinge to body 33.3~41.2 3.4~4.2 24.6~30.4 Door hinge to door 21 ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid ...

See also:

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

Auto Defogging Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the auto defogging sensor cover (A). 3. Disconnect t ...

Evaporator Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistan ...

Copyright В© www.ksmanual.com 2014-2024