Kia Optima Manuals

Kia Sorento: Installation - SS-A Solenoid Valve(ON/OFF) - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) / Installation

1.
Install in the reverse order of removal.
  
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

See also:

Fuel Filter Removal
1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). ...

Power Mosfet (DATC) Inspection
1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be rep ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Categories

Copyright www.ksmanual.com 2014-2026