Kia Sorento: Brake Pedal Installation - Brake System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Brake Pedal Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Brake System / Brake Pedal Installation

1.
Pre-tighten the bracket fixing bolt (A) in dash panel.

2.
Install the brake booster and brake pedal member fixing nuts (A) securely.

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

3.
Tighten the bolt (A) securely in dash panel.

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

4.
Install the snap pin (A) and clevis pin (B).

  
Before installing the pin, apply the grease to the clevis pin.
Use a new snap pin whenever installing.
5.
Install the stop lamp switch securely.
6.
Connect the stop lamp switch connector (A).

7.
Adjust the brake pedal height and free play.
8.
Check the brake pedal operation after installing the brake pedal.
9.
Install the shower duct (A).

10.
Install the crash pad lower panel.
11.
Reconnect the battery negative cable.
Brake Pedal Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

Brake Pedal Adjustment
Brake Pedal Height and Free Play 1. Disconnect the stop lamp switch connector (A) and loosen the stop lamp switch lock nut. 2. ...

See also:

Passenger Airbag (PAB) Module Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

Cylinder Head Cover Installation
1. Install cylinder head cover. (1) The hardened liquid gasket sealant located on the upper area between timing chain cover and cyli ...

Side Airbag (SAB) Module Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Si ...

Copyright www.ksmanual.com 2014-2026