Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat.
(Refer to Body - "Rear ...
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling as it exits th ...
See also:
Schematic Diagram
...
Installation
1.
Install in the reverse order of removal.
If the oil seal on the trans ...
Yaw-rate and G Sensor Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Removal
Injector