Kia Sorento: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
RemovalSteering Column and Shaft Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...
Console Components
[M/T]
1. Floor console assembly
2. Console upper cover
3. Console side cover [LH]
4. Console side cover [RH]
5. Rear console cover
6. Floor console mounting ...
Fuel Sender Installation
1.
Install in the reverse order of removal.
...