Kia Sorento: Fuel Filler Door Release Actuator Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator Inspection
| 1. |
Remove the fuel filler cover (A) after loosening screws (2EA).
|
| 2. |
Remove the fuel filler door module (A).
|
| 3. |
Remove the rear 3rd seats.
(Refer to Body - "Rear seats")
|
| 4. |
Remove the luggage side trim.
(Refer to Body - "Interior trim")
|
| 5. |
Disconnect the fuel filler door release actuator connector (A).
|
| 6. |
Check for continuity between terminal No. 1 and No. 2. If there
is no continuity, replace the fuel filler door release actuator (A).
|
Component Location
1. Fuel filler door open switch
2. Fuel filler door release actuator
...
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...
See also:
Front Fog Lamps Inspection
1.
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunctio ...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026