1. |
Remove the front door trim panel.
(Refer to Body - "Front door")
|
2. |
Disconnect the switch connector (A) from wiring.
|
3. |
Check the switch for continuity between the No. 1 and No. 2 terminals.
If the continuity is not as specified, replace the switch.
|
Replacement
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Power Tailgate Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear left luggage side trim.
(Refer to Body - "Interior Trim")
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS termi ...