1. |
Install the spring lower pad (D) so that the protrusions(A) fit
in the holes (C) in the spring lower seat (B).
|
2. |
Compress coil spring using special tool (09546-26000). Install
compressed coil spring into shock absorber.
|
3. |
After fully extending the piston rod, install the spring upper
seat and insulator assembly.
|
4. |
After seating the upper and lower ends of the coil spring (A)
in the upper and lower spring seat grooves (B) correctly, tighten new
self-locking nut temporarily.
|
5. |
Remove the special tool (09546-26000).
|
6. |
Tighten the self-locking nut to the specified torque.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Removal
1.
Remove the mirror wiring cover (A).
2.
Remove the mirror mounting screw (A) and connector (B).
3.
...
Starter Removal
1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - &quo ...