Kia Sorento: Rear Stabilizer Bar Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
In the case of 4WD vehicle, remove the rear differential assembly.
(Refer to Driveshaft and axle - "Rear Differential Carrier")
|
| 3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
| 4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
| 5. |
Installation is the reverse of removal.
|
Rear Assist Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear assist arm for deformation.
...
Rear Stabilizer Bar Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
...
See also:
Emergency Fastening Device (EFD) Removal
1.
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
2.
Remove the EFD cover pad (A).
...
Transaxle Oil Temperature Sensor Removal
1.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
2.
Remove the under cover.
...
Description
Limitations Of The Navigation system
GPS Signal Reception State
As the GPS satellite frequency is received/transmitted in straight lines,
reception may not work if hiding devices are pla ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026