Kia Optima Manuals

Kia Sorento: Front Impact Sensor (FIS) Installation - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Impact Sensor (FIS) Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Installation

  
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque
: 6.8 ~ 9.2 Nm (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb.ft)
3.
Connect the front impact sensor connector.
4.
Reconnect the battery negative cable.
5.
After installing the front impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Removal
   • Removal of the airbag must be performed according to the precautions/ procedures des ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

See also:

Tightening Torque
Items N.m Kgf.m lb-ft Front and rear doors Door hinge to body 33.3~41.2 3.4~4.2 24.6~30.4 Door hinge to door 21 ...

Parking Brake Assembly Installation
Parking Brake Shoe 1. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring. 2. Install the ope ...

IPM Installation
1. Install IPM(Intelligent intergrated Platform Module). 2. Connect the IPM connector. 3. Install the crash pad ...

Categories

Copyright www.ksmanual.com 2014-2026