Kia Sorento: Side Impact Sensor (SIS) Description - SRSCM - Restraint - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Side Impact Sensor (SIS) Description

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description

Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar nearby (LH and RH).
Front-Side Impact Sensor (F-SIS) is also called P-SIS because that detects pressure due to collision at its mounting location.
Rear-Side Impact Sensor (R-SIS) is also called A-SIS because that detects acceleration.
SRSCM decides deployment or not of the airbag and the time of deployment through the collision signal of SIS when the collision occurred.
Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

Side Impact Sensor (SIS) Components
...

See also:

Water Temperature Control Assembly Components
1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant ho ...

Description
BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) al ...

Front Driveshaft Components
1. Front driveshaft (LH) 2. Inner shaft bearing bracket 3. Front driveshaft (RH) [LH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ bo ...

Copyright В© www.ksmanual.com 2014-2023