Kia Sorento: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Front Impact Sensor (FIS) Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Removal

  
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Disconnect the front impact sensor connector (A).
3.
Remove the front impact sensor mounting bolt (B).

Front Impact Sensor (FIS) Components
...

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Components Location
1. AVN (A/V & Navigation) head unit 2. Tweeter speaker 3. External amplifier 4. Roof antenna (Radio+Sirius+GPS) 5. Front door speaker 6. Rear door speaker 7. Subwo ...

Component Replacement After Deployment
   Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing ...

Components
2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm ...

Copyright © www.ksmanual.com 2014-2023