Kia Sorento: Rheostat Inspection
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Lighting System / Rheostat Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad side cover.
|
| 3. |
Remove the lower crash pad switch assembly (A) after loosening
the screws.
|
| 4. |
Remove the rheostat switch connector (A).
|
| 5. |
Remove the rheostat switch (A) from lower crash pad switch assembly.
|
| 6. |
Check for intensity of new rheostat switch. If the light intensity
of the lamps changes smoothly without any flickering when the rheostat
is turned, it can be assumed that the rheostat is normal.
|
Hazard Lamp Switch Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of IPM with GDS quickly. GDS
can operates actuator forcefully, input/output value monitoring and
self dia ...
Front Fog Lamps Inspection
1.
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunctio ...
See also:
Front Body B
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Oil Pan Installation
1.
Install the oil pan.
(1)
Using a gasket scraper, remove all the old sealant material
from the gasket surfaces.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025