Kia Sorento: Evaporator Core Replacement
|
1. |
Disconnect the negative (-) battery terminal.
|
|
2. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
|
|
3. |
Remove the heater unit lower case (A) after loosening the mounting
screws.
|
|
4. |
Pull out the evaporator core (A) from the heater unit.
|
Be careful that the inlet and outlet pipe are not bent
during heater core and evaporator core removal/installation.
|
|
|
5. |
Install in the reverse order of removal.
| A. |
If you're installing a new evaporator core, add refrigerant
oil (PAG OIL).
|
| B. |
Replace the O-rings with new ones at each fitting, and
apply a thin coat of refrigerant oil before installing them.
Be sure to use the right O-rings for R-134a to avoid leakage.
|
| C. |
Immediately after using the oil, replace the cap on the
container, and seal it to avoid moisture absorption.
|
| D. |
Do not spill the refrigerant oil on the vehicle; it may
damage the paint; if the refrigerant oil contacts the paint,
wash it off immediately.
|
| E. |
Apply sealant to the grommets.
|
| F. |
Make sure that there is no air leakage.
|
| G. |
Charge the system and test its performance.
|
| H. |
Do not interchange the inlet and outlet heater hoses and
install the hose clamps securely.
|
| I. |
Refill the cooling system with engine coolant.
|
|
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
...
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump
and controls fuel flow flowing into the injectors in accordance with the ECM
signal calculated based on various engine ...
Smart key unit Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing (A).
(Refer to Body - "Crash pa ...
Heater Core Replacement
Temperature Control Actuator Description