Kia Sorento: ETC (Electronic Throttle Control) System Removal and Installation

Removal

1.	Disconnect the battery negative ( - ) terminal.

2.	Remove the air cleaner. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the Electronic Throttle Control (ETC) module connector (A).

Remove the ETC module (A) after removing the mounting bolts.

Tightening torque :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Engine Control / Fuel System — Engine Control System / ETC (Electronic Throttle Control) System / Removal and Installation / Removal illustration

Installation

Install in the reverse order of removal.

•	Install the Electronic Throttle Control (ETC) module to the specified torque.

•	If the ETC module is dropped, it may cause internal damage. (Do not reuse)

•	Check the seal ring (A) installation before installing the ETC module.

Perform the order below with the KDS.

(S/W Management → Engine Control → Resetting Adaptive Values)

Refer to the KDS screen for operating conditions and details.

3.	Perform the ETC learning procedure. (Refer to ETC (Electronic Throttle Control) System - "Adjustment")

Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fa...

Adjustment ...

Manuals list