Kia Sorento: Engine Room Under Cover Removal and Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Removal and Installation

1.

Unfasten the fasteners and bolts and then remove the engine room under cover (A).

Tightening torque:

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

2.

Remove the engine room side cover(A).

Tightening torque:

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

[RH]

[LH]

3.	Install in the reverse order of removal.

Engine Room Under Cover Components

1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH) ...

Engine Mounting Components

1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

See also:

Yaw-rate and G Sensor Installation
1. Remove the ignition key from the vehicle. 2. Install inthe reverse order of removal. 3. After installing the ...

Driving your vehicle
WARNING - Engine exhaust can be dangerous! Engine exhaust fumes can be extremely dangerous. If, at any time, you smell exhaust fumes inside the vehicle, open the windows immediately. Do not inha ...

Side Body B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Categories

Copyright © www.ksmanual.com 2014-2025