1. |
Set the front tires straight-ahead before removing the steering
wheel.
|
2. |
Disconnect the battery negative cable.
|
3. |
Release the connector locking pin, then disconnect the driver
airbag module connector(B).
|
4. |
Remove the steering wheel and steering wheel column shroud. (Refer
to the Steering System group- Steering Column and Shaft)
|
5. |
Disconnect the clock spring and horn connector, then remove the
clock spring.
|
Compressor Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the
engine.
The compressor changes low pressure and low temperatur ...
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Components
1. Blind Spot Detection (BSD) Unit
2. BSD switch
3. Speaker (Built in the cluster)
4. BSD warning lamp (Built in the outside mirror)
...