Kia Sorento: Driver Airbag (DAB) Module and Clock Spring Inspection - Airbag Module - Restraint - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Driver Airbag (DAB) Module and Clock Spring Inspection

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Inspection

Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag module with a new one.
  
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
1.
Check pad cover for dents, cracks or deformities.
2.
Check the airbag module for denting, cracking or deformation.
3.
Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4.
Check airbag inflator case for dents, cracks or deformities.

5.
Install the airbag module to the steering wheel to check for fit or alignment with the wheel.
Clock Spring
1.
If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a new one.
2.
Check connectors and protective tube for damage, and terminals for deformities.

Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel.    ...

Driver Airbag (DAB) Module and Clock Spring Installation
1. Set the front tires straight-ahead before assembling the steering wheel.    ...

See also:

Camshaft Position Sensor (CMPS)
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the piston pos ...

IPM Installation
1. Install IPM(Intelligent intergrated Platform Module). 2. Connect the IPM connector. 3. Install the crash pad ...

Using the USB device
To use an external USB device, make sure the device is not connected when starting up the vehicle. Connect the device after starting up. If you start the engine when the USB device is connected ...

Copyright В© www.ksmanual.com 2014-2023