Kia Sorento: Accelerator Pedal Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (C), the bolt (B) and then remove
the accelerator pedal module.
|
Filler-Neck Assembly Installation
Accelerator Pedal InstallationDescription
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
Blind Spot Detection Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
...
Panorama Sunroof Motor Replacement
Resetting The Panoramaroof
Whenever the vehicle battery is disconnected or discharged, or you use
the emergency handle to operate the panoramaroof, you have to reset your panoramaroof
sys ...