1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the glove box housing.
(Refer to Body -"Crash Pad")
|
3. |
Disconnect the cluster ionizer connector (A).
|
4. |
Remove the screws and then remove the cluster ionizer (B).
|
5. |
Install in the reverse order of removal.
|
Front Driveshaft Removal and Installation
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Front Washer Motor Inspection
Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
&nb ...
Fuel Line Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the F ...