1. |
Press the MODE switch more then 4 times within 2 seconds while
pressing the OFF switch.
* For diagnostic procedure, refer to DTC guide.
|
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Accelerator Pedal Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18 ...
Rear Glass Defogger Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...