Kia Sorento: Blind Spot Detection Unit Removal - Blind Spot Detection System - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Blind Spot Detection Unit Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
3.
Remove the BSD unit (A) after loosening the mounting screws.

  
Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Blind Spot Detection Unit Circuit Diagram
...

Blind Spot Detection Unit Installation
1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery te ...

See also:

Head Lamps Removal
   Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turn ...

Pressure Sensor Removal
1. Remove the coupling assembly. (Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling") 2. Remove th ...

Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") ...

Copyright В© www.ksmanual.com 2014-2023