Kia Sorento: Blind Spot Detection Unit Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Installation
| 1. |
Install the BSD units to the rear bumper.
|
| 2. |
Install the rear bumper.
|
| 3. |
Connect the negative (-) battery terminal.
|
|||||||||||||
Blind Spot Detection Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
...
Blind Spot Detection Unit Inspection
BSD Unit Alignment
To sense the cars exactly in the next lane with the radar, the direction
of the sensor and the direction of the vehicle have to align.
This is BSD unit alignm ...
See also:
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve
...
AC Inverter Switch Removal
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
TPMS Receiver Operation
1.
General Function
A.
Auto learn takes place only once per Ignition cycle.
B.
On successful compl ...
Copyright В© www.ksmanual.com 2014-2024