The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
4. |
Remove the parking brake lever assembly (A) after removing the
bolts.
|
Ignition Coil Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...
User Settings Mode
Description
On this mode, you can change setting of the doors, lamps, and so on.
Door
Auto Door Lock (if equipped)
• Off:
The auto door lock operation will be deactivated.
• Speed: ...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...