Kia Sorento: Blind Spot Detection Switch Circuit Diagram

Blind Spot Detection Unit Inspection

BSD Unit Alignment To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignm ...

Blind Spot Detection Switch Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") ...

See also:

Room Lamp Removal
[General] 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver t ...

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Installation
   • Install the component with the specified torques. • ...