Kia Sorento: Driver Airbag (DAB) Module and Clock Spring Inspection - Airbag Module - Restraint - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Driver Airbag (DAB) Module and Clock Spring Inspection

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Inspection

Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag module with a new one.
  
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
1.
Check pad cover for dents, cracks or deformities.
2.
Check the airbag module for denting, cracking or deformation.
3.
Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4.
Check airbag inflator case for dents, cracks or deformities.

5.
Install the airbag module to the steering wheel to check for fit or alignment with the wheel.
Clock Spring
1.
If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a new one.
2.
Check connectors and protective tube for damage, and terminals for deformities.

Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel.    ...

Driver Airbag (DAB) Module and Clock Spring Installation
1. Set the front tires straight-ahead before assembling the steering wheel.    ...

See also:

Driving with a trailer
Towing a trailer requires a certain amount of experience. Before setting out for the open road, you must get to know your trailer. Acquaint yourself with the feel of handling and braking with the ad ...

Description
EPS (Electric power steering, Column assist type) system uses an electric motor to assist the steering force and it is an engine operation independent steering system. EPS control module ...

ICM Relay Box Inspection
Rear Wiper Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.1 and No.3 terminals when power and ground are conne ...

Copyright www.ksmanual.com 2014-2025