1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Power Tailgate Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear left luggage side trim.
(Refer to Body - "Interior Trim")
...
Installation
1.
Install the key lock cylinder.
2.
Install the illumination bulb, lens and cover.
3.
Install the key warning ...