Kia Sorento: Removal - 26 Brake Control Solenoid Valve(26/B_VFS) - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) / Removal

  
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
Inspection
1. Turn ignition switch OFF. 2. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") ...

Line Pressure Control Solenoid Valve
line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

See also:

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

ICM Relay Box Inspection
Rear Wiper Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.1 and No.3 terminals when power and ground are conne ...

Photo Sensor Inspection
1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lam ...

Copyright www.ksmanual.com 2014-2026