Kia Sorento: Description

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

On-vehicle Inspection

Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

See also:

Front Strut Assembly Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Crankshaft Damper Pulley Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the passenger engine room side cover. (Ref ...

Lift And Support Points
   When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place addition ...