Kia Sorento: Injector

The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.The ECM controls both the feed circuits (high side) to feed voltage to the injectors and the ground circuits (low side) to energize the injectors. Also, the feed for 2 injectors comes from the same driver set. As the ignition coils are paired with cylinders (1-4 and 2-3), the injectors are also set up in pairs.

Installation

   • Install the component with the specified torques. • ...

Specification

Item Specification Coil Resistance (Ω) 1.18 ~ 1.31 [20°C(68°F)] ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear ...

3. TCM Terminal input/ output signal
Connector [A] Pin No. Signal Condition Type Level 29 Sports mode up switch Up ON Input 0V/Battery voltage level ...

Circuit Diagram
...