Kia Sorento: Drive Belt Tensioner Removal and Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.

Remove the drive belt auto tensioner(A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Tensioner pulley bolt is left-hands screw.

3.

Remove the drive belt tensioner (A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

4.	Install in the reverse order of removal.

Idler Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightenin ...

Crankshaft Damper Pulley Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the passenger engine room side cover. (Ref ...

See also:

Seat Heater Installation
1. Install the driver / assist seat heater. (Refer to Body - "Front seat") 2. Install the rear seat LH heater and RH heater. ...

HID Head Lamp
1. Bulb (1) Elements Xenon gas: Xenon gas activates the initial reaction for rapid illuminating. Molybdenum ...

Auto Defogging Actuator Description
The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives ...

Categories

Copyright © www.ksmanual.com 2014-2025