Item |
Specification |
||
Compressor |
Type |
DVE18 (External Variable Displacement Swash Plate) |
|
Oil type & Capacity |
Front only |
PAG 120± 10cc (4.1±0.3oz.) |
|
Front & Rear |
PAG 180 ± 10cc (6.1±0.3oz.) |
||
Pulley type |
6PK-TYPE |
||
Displacement |
180cc/rev |
||
Condenser |
Heat rejection |
DSL : 14,600-5% kcal/hr (16.1-5% kw) GSL : 16,000-5% kcal/hr (18.8-5% kw) |
|
Expansion valve |
Type |
Block type |
|
Refrigerant |
Type |
HFC-134a |
|
Capacity |
Front only |
600 ± 25g (21.1 ± 0.88oz.) |
|
Front & Rear |
750 ± 25g (26.4 ± 0.88oz.) |
Item |
Specification |
|
Fresh and recirculation |
Operating method |
Actuator |
Blower |
Type |
Sirocco |
Speed step |
Auto + 8 speed (Automatic), 1~4speed (Manual) |
|
Speed control |
Power mosfet (Automatic), Resistor (Manual) |
|
Air filter |
Type |
Particle filter |
Item |
Specification |
|
Heater |
Type |
Pin & Tube type |
Heating capacity |
4,700 - 5% kcal/hr |
|
Mode operating method |
Actuator |
|
Temperature operating method |
Actuator |
|
Evaporator |
Temperature control type |
Evaporator temperature sensor |
A/C ON/OFF |
ON: 3.0±0.3°C (37.4±0.5°F) OFF: 1.0±0.3°C (33.8±0.5°F) |
Shift Cable Adjustment
Adjusting method for T/M control cable
1.
Set room side shift lever and T/M side manual control lever to
"N" position.
2.
...
Passenger Airbag (PAB) Module Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least thirty seconds bef ...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to damage
the washer pump seal.
...