Kia Sorento: Drive Belt Inspection - Timing System - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Drive Belt Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Timing System / Drive Belt Inspection

1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  
Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Drive Belt Removal and Installation
1. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A). 2. Install the drive be ...

Idler Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightenin ...

See also:

Front Body A
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Master Cylinder Removal
1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. G 2.4 GDI (Refer to ...

Front Strut Assembly Components
1. Strut assembly 2. Insulator 3. Bearing 4. Spring upper pad 5. Spring 6. Dust cover 7. Spring lower pad ...

Copyright В© www.ksmanual.com 2014-2024