Kia Sorento: Power Mosfet (DATC) Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the passenger side crash pad under cover (A).
|
| 3. |
Disconnect the connector and then remove the power mosfet (A)
after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Power Mosfet (DATC) Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower
resistor must be rep ...
Climate Control Air Filter Description
The climate control air filter is located in the blower unit. It eliminates
foreign materials and odor. The particle filter performs a role as an odor filter
as well as a conventional dust fi ...
See also:
Component Location
1. Head lamp leveling sensor & unit
2. Head lamp leveling actuator
...
Rear Body
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Side outer p ...
Steering Column and Shaft Inspection
1.
Check the steering column for damage and deformation.
2.
Check the joint bearing for damage and wear.
3.
Che ...
Copyright В© www.ksmanual.com 2014-2024