1. |
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch.
|
Starter Disassembly
1.
Disconnect the M-terminal (A) on the magnet switch assembly (B).
2.
After loosening the screws (A), detach the magnet switch assembly ...
Balance Shaft & Oil Pump Components
1. Balance shaft & oil pump assembly
2. Balance shaft chain tensioner
3. Balance shaft chain
4. Balance shaft chain sprocket
5. Balance shaft chain guide
6. Balance shaft ...
Rear Driveshaft Removal and Installation
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...