Kia Sorento: A/C Pressure Transducer Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2022 Service ManualKia Sorento: A/C Pressure Transducer Replacement

Second Generation XM (2011-2022) / Kia Sorento XM 2011-2022 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).

Tightening torque :
10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7.4 ~ 8.8 lb-ft)

  
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.

  
When installing, replace it with a new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal У1Ф and У2Ф. 2. Inspect the voltage valu ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...

See also:

Auto Defogging Sensor Description
The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module rece ...

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

AUX(Auxiliary) Jack Installation
1. Install the Multimedia jack. 2. Install the console upper cover. ...

Copyright © www.ksmanual.com 2014-2022