Kia Sorento: Water Temperature Control Assembly Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Loosen the drain plug and drain the engine coolant.
|
| 3. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator")
|
| 4. |
Disconnect the connectors and then remove the wiring protector (A).
|
| 5. |
Disconnect the E.T.C cooler hose (A) and the remove the water temperature
control assembly(A).
|
| 6. |
Install in the reverse order of removal.
|
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Thermostat Removal and Installation
Removal of the thermostat would have an adverse effect, causing a lowering
of cooling efficiency. Do not remove the ther ...
See also:
Description
The SMART KEY system is a system that allows the user to access and operate
a vehicle in a very convenient way. To access the vehicle, no traditional key
or remote control unit is needed.
...
Purge Control Solenoid Valve (PCSV)
Purge Control Solenoid Valve (PCSV) is installed on the surge tank and
controls the passage between the canister and the intake manifold. It is a solenoid
valve and is open when the ECM groun ...
Heated Steering wheel System Circuit Diagram
Terminal Function
Housing
Pin
Function
Wire color
Pad
A
GND
Back
B
HEATER
Yellow
C
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026