Kia Optima Manuals

Kia Sorento: TPMS Sensor Removal - Tire Pressure Monitoring System - Suspension System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: TPMS Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Removal

Tire Removal
1.
Deflate tire & remove balance weights.
  
•
The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.
•
Avoid tire/tool contact with the valve on dismount.
•
Dismount should end near the valve.

Sensor Removal
  
Handle the sensor with care.
1.
Remove the valve nut.

  
The valve nut should not be re-used.
2.
Discard the valve assembly.
TPMS Sensor Description
1. Mode (1) Configuration State A. All sensors should be in the Low Line state. ...

TPMS Sensor Installation
Sensor Fit    • Handle the sensor with care. • ...

See also:

Rear Coil Spring Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Specifications
Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 0 ~ 539.37 (0 ~ 5.5, 0 ~ 78.23) Current value(mA) ...

Circuit Diagram
Connector Pin Information No. Wire harness connector Panorama motor Blind motor 1 Ground 1 ...

Categories

Copyright www.ksmanual.com 2014-2026